Power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE 1
General Description
This power unit is made exclusively for that little lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit has been broadly made use of during the field of logistic products for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled from the solenoid valve using the velocity managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is designed solely for that medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve and also the velocity managed through the adjustable needle valve. When the lift rises to a substantial positoin, but the energy provide is lower, the decreasing motion is managed by the guide override perform.
Electrical power UNITS FOR LIFT TABLE 3
General Description
This energy unit is built exclusively for your big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve and also the pace managed by a strain compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This energy unit is created exclusively for the big lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as pace managed through the adjustable needle valve. When the lift rises to a high positoin, but the power supply is lower, the decreasing motion is controlled by the manual override function.
Special Notes
1. This energy unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean every one of the hydraulic components concerned just before set up of the power unit.
three. Viscosity from the oil shoud be 15~46 cst,which need to also be clean and no cost of impurities.N46 hydraulic oil is advised.
4. Oil altering is required right after the initial one hundred operation hours,afterwards when each and every 3000 hours.
five. The power unit shown is created to be mounted vertically.